The Leica L2 fibre-optic light source:
– must always be locked into an adapter when it is in
use (see page 14). This ensures its stability.
– must only be used in a vertical position with the light-
guide connector at the top (see page 14).
– must be set up so that all ventilation holes are free
(see page 14).
– Unplug the power cable from the mains socket.
– Never touch the inside of the lamp housing when
the power supply is connected.
– Wait for the halogen bulb to cool before you try to
change it. If you touch a hot bulb, you may suffer
burns. There is a warning symbol inside the door
of the lamp compartment as a reminder (see page 21).
Setting up the
Leica L2 fibre-optic
light source
Changing the bulb
8
Leica L2 User manual – Safety precautions during use
To Next Page
Loading...
