To Next PageTo Next PageWhy is my Leica Laser Level receiver not working properly?
Several factors can cause this. The Rugby might not be rotating because it is levelling or in Elevation Alert. Ensure the Rugby is operating correctly. You may be out of the receiver's usable range, so move closer to the Rugby. Alternatively, the receiver batteries might be low, so try changing them.
What to do if my Leica Rugby Laser Level does not turn on?
If your Rugby laser level isn't turning on, the batteries may be low or dead. Check the batteries and replace or charge them if needed.
How to fix Leica Rugby 820 Laser Level Rugby when it is working, but not self-levelling?
If your Rugby laser level is working but not self-levelling, it might be in Manual Mode. The Rugby must be in Automatic Mode to self-level. Set the Rugby to Automatic Mode by pressing the Automatic/Manual Mode button. When in Automatic Mode, the X-axis LED and the Y-axis LED will flash green while levelling. In Manual Mode, the X-axis LED and/or the Y-axis LED will be red.
Why is the distance of the laser reduced on my Leica Rugby Laser Level?
A reduced laser distance could be due to dirt reducing the laser output. Clean the windows of both the Rugby and the receiver.
What to do if the Elevation Alert function is not working on my Leica Rugby 820 Laser Level?
If the Elevation Alert function isn't working, it may be disabled. To enable or disable it: turn on the Rugby and ensure it's rotating, then press and hold the Up and Down Arrow buttons. While holding these, press the Automatic/Manual Mode button. The Rugby will beep once to indicate the change.
How to fix Leica Rugby Laser Level when it does not switch to Manual Mode?
If the Rugby beeps three times when you press the Automatic/Manual Mode button but doesn't switch to Manual Mode, the Manual Mode might be disabled. To enable or disable it, turn off the Rugby, then press and hold both the Automatic/Manual Mode button and the Power button for 5 seconds. The Rugby will beep five times, followed by a longer beep to indicate the change.
Why is Smart Target feature not working on my Leica Rugby 820 Laser Level?
The Smart Target feature may not work because the Rugby 820 and the receiver haven't been paired and can't communicate. Pair the Rugby 820 and the receiver.
General| Type | Rotary Laser Level |
|---|---|
| Accuracy | ± 1.5 mm at 30 m |
| Protection Class | IP 68 |
| Self-Leveling Range | ± 5° |
| Range | Up to 800 m with detector |
| Power Supply | Rechargeable Li-Ion battery pack |
| Laser Diode Type | 635 nm |
| Operating Temperature | -20 °C to +50 °C |
