Leigh rtj400 - Router Table Requirements

66
RTJ400 User Guide
Introduction
1
3
/ 8 "
0.100
"
1
3
/ 16 "
Router tables are typically used with a bearing or fence, however, the Leigh RTJ400 is guided around a guide bushing mounted in the
router table. Leigh eBushes (guide bushings) are designed around the decades-old Porter Cable/Black & Decker industry standard.
Therefore, you will need an insert ring to fit the eBush to your router table or router plate. See specifications below.
■
Router Table Requirements
Router Table
eBush
Insert Ring
Insert Plate
1
3
/16"
1
3
/8"
0.100"
To fit the eBush to your router table
insert plate, you need a 1-3/8" diameter
counter bore insert ring. Check with
your router table or router plate
(router lift) manufacturer, as to what
adaptation, if any, is required.
Leigh eBush and Nut