Leigh rtj400 - Page 9

9
9
RTJ400 User Guide Chapter 1
Assembling the RTJ400
A
B
1-8 The frame is located on the template by a pin on the frame
handles. Place the frame on the template by inserting the right
frame pin in the ALL TD TAILS hole
A
and the left frame pin in
the
TD TAILS & BJ slot
B
.  To prevent damage to the frame
pin always remove the right frame pin first when lifting the
frame handle.
1-9 Pivot both latches to secure the frame to the template.
Double check the latches to ensure they are fully seated.
 Only when the frame is latched securely is it safe to lift and
or carry the jig by the handles.
1-7 Stop Rod: Insert the stop rod in the
¾" slot
A
. The
stop rod remains here for all routing operations except half-blind
dovetails and box joints. Note: The stop rod may have been
shipped in this location.
1-12 You will have leftover parts. Keep them to use as required
for various jig operations.
■
A
1-10 If not already in channel, slide the Quick Reference strips
into the channel in the top of the jig
A
.
Leftover parts:
• bit depth gauge
• ten blockers
• e10 guide bushing & nut
• pin wrench
• DVD
• this user guide
A
1-11 Store the hex key in the left hand handle.