Mains lead and Remote Control Cable
are enclosed in the package. These leads may
be stored in the magazine chamber. Cords
must be stored in such a way that the lid
closes properly.
Connecting to the Mains Supply
The motor of the prodovit is designed for
operation from A. C. mains of
110/125
V,
50
cycles,
110/125
V,
60
cycles or
220
V,
50
cy-
cles. A universal motor to be used for voltages
between
110-240
V and
50-60
cycles is avail-
able as well. This model must be connected
according to the prevailing current. Therefore
check the type and voltage of the supply
before
connecting the projector. Note also
the data panel on the inside of the magazine
chamber lid.
The projection-lamp must also be rated at the
same voltage.
Connecting the Remote Control Cable
Plug in the remote control cable with the red
line on the plug opposite the red dot on the
back of the body. Push the plug home firmly.
4
To Next Page
Loading...