LELY E-LINK D 6060 - Page 30

DIAGNOSIS menue
30 E-LINK D 6060 • D 4060
Attention, danger of injury!
Standard diagnosis may only be performed after the
machine has been stopped: Switch off tractor engine, wait
until machine has stopped, disconnect hydraulic supply to
the machine.
 Toggling between automatic and manual diagnosis: key
<
> (START/STOP).
In the Diagnosis Automatic mode all channels are automatically
triggered and tested in succession.
The following symbols are used for the actor status:
Symbol Actor status
Actor channel is OK.
Actor channel is faulty.
Actor channel cannot be triggered.
Here: Automatic diagnosis
Valve diagnostic 1/2
Valve diagnostic 1/2Valve diagnostic 1/2
Valve diagnostic 1/2
Automatic
AutomaticAutomatic
Automatic
Val. B
Val. BVal. B
Val. B
Val. C
Val. CVal. C
Val. C
Val. 45
V
al. 45Val. 45
V
al. 45
Fan
FanFan
Fan
Tying
TyingTying
Tying
Val. 67
Val. 67Val. 67
Val. 67
Val. 89
V
al. 89Val. 89
V
al. 89
PU STOP
P
U STOPPU STOP
P
U STOP
Because of special
properties, the actor
channel "Tying" is not
tested in the Automatic
Diagnosis.