5. BASIC OPERATING
INSTRUCTIONS
This section has only those operating instructions to safely operate and do
maintenance on the Juno 100.
The full set of operating instructions can be found in the installation &
operation manual.
5.1 Switch ON or OFF the Juno 100
The Juno 100 does not need to be switched OFF during normal operation.
To switch ON
1. Open the cover.
2. On the pcb box, push button [ON] to switch ON the Juno 100.
3. Close the cover.
To switch OFF
1. Open the cover.
2. On the pcb box, push button [OFF] to switch OFF the Juno 100.
3. Close the cover.
5.2 Open or Close the Cover
Stop the timed actions before you open the cover. By stopping the time path
the Juno 100 and its shock system (option) are taken out of operation.
The Juno 100 stops immediately when the cover is opened.
To open.
1. Open the cover (1).
2. Make sure the bracket (2) keeps the cover open.
To close
1. Hold the cover (see figure on page 5‑3).
2. Pull the bracket (2) forward.
3. Close the cover.
Basic Operating Instructions
5-1
F-A102.1401EN
To Next Page
Loading...
