2.2 Electrical Safety
• Only an authorized electrician must install the electrical power supply for
the charging station of the Juno 100.
• Make sure the electrical grounding of the electrical system and all parts of
the charging station of the Juno 100 meet the local rules and regulations.
• Replace any damaged electrical lines, conduits, switches and
components immediately .
• Switch the power OFF with the OFF button on the ADS 3840 PCB before
you start to work on the system.
• Pull the plug from the socket before you start to work on the charging
station.
2.3 Operating Safety
• Read and understand this manual and all safety signs before you connect
power supplies to operate, maintain or adjust the Juno 100
• Only trained persons are permitted to operate the Juno 100
• Make sure all covers are installed before you operate the Juno 100
• Only operate the Juno 100 in a closed and marked feed alley
• The Juno 100 shall be operated under supervision only or in areas that
are not accessible for unauthorized people, especially small children
• Keep hands, feet, hair and clothing away from all moving parts
• Never touch the collision detector (2) when the Juno 100 is moving to
avoid an electric shock
2-2
Safety Instructions
F-A102.1401EN
To Next Page
