6
danger of injury by bruising and crushing!
• Before leaving the tractor lower the machine to the ground. Apply the parking
brake, stop the engine and remove the ignition key!
• Do not allow anybody between the tractor and implement if the parking brakes
are not applied!
Attached implements
• Before mounting or dismounting implements on/from the three-point linkage,
move the raise / lower control to the position at which accidental raising or
lowering cannot take place!
• In the case of three-point linkage mounting, ensure that the tractor balls and
the mounting pins of the implement are of the same category!
• There is the risk of injury from pinch and shear points in the three-point linkage
area!
• When operating the external lift controls for the three-point linkage, do not
stand between the tractor and implement!
• Always ensure sufficient lateral limitation for the three-point linkage of the
tractor in the transport position of the implement!
• When driving on roads with the implement raised, the raise/lower control must
be locked to prevent lowering!
Tyres
• When working on the tyres make sure that the implement has been placed on
the ground safely and that it is secured by chocks against unintentional rolling!
• Fitting tyres requires knowledge and special tools!
• Repairwork on tyres may only be conducted by trained staff and with suitable
tools!
• Check air pressure regularly and adhere to the advised air pressure!
Maintenance
• Repair-, maintenance- and cleaning operations as well as adjustments and
remedy of function faults should principally be conducted with engine stopped
and brakes applied. Remove ignition key!
• Check and tighten nuts and bolts regularly!
• When conducting maintenance work on a lifted implement always place
suitable supports underneath!
• For replacing any tools with cutting edges always use suitable tools and
gloves!
• Dispose of old oils, grease and filters as prescribed by law.
• Before working on the electric gear disconnect battery cables!
• When conducting electrical welding operations on the tractor or on the
mounted implement remove cable from the generator and the battery!
• Any spare parts fitted must meet with the implement manufacturer’s fixed
technical standards! This is for example ensured by using genuine spare parts!
To Next Page
Loading...
