Lemon LM0086 - Activating a Stabilization Option; Stabilization ON;OFF Channel

7CH Essential Instructions R1.0 2022/11/08
5
Activating a Stabilization Option
To activate stabilization, the receiver must be programmed with one of five optional configurations, indicated by
the three red programming LEDs: R1, R2 and R3. The options and the corresponding lights are as follows:
4
Option A: Delta Wing (Elevons) – R1
Option B: V-Tail – R2
Option C: Normal (conventional tail) – R1+R2
Option D: Dual Aileron Channels with normal tail – R1+R2+R3
Option E: Dual Aileron Channels with V-Tail – R2+R3
To set a Mix option, proceed as follows (the transmitter is not required except to test results of programming):
1. With the receiver OFF, place a Bind Plug on the channel 6 pins.
2. Press button C and hold while powering ON the receiver.
3. Release button C when all six programming LEDs flash (three red, three green).
4. Red LEDs will now turn on for 3 seconds in the following sequence: R1, R2, R1+R2, R3.
5. When the desired option is reached, tap button C twice in quick succession to change the state of the
option from OFF to ON.
6. Allow the receiver to exit from Mixing mode.
7. If appropriate, repeat the process to set dual aileron channels (R3) in the same manner.
8. Remove Bind Plug from channel 6 pins.
Example: Option D is required to stabilize a model with normal tail and dual aileron channels. Start by setting
Option C (R1+R2). Then, in a separate operation, set R3. The result will be all three red programming lights ON.
Note that either R1 or R2 or both must be ON for stabilization to be active. Thus, setting R3 without either
Option B or Option C will have no effect. Settings are retained even when power is removed.
Once a stabilized option is set, stabilization can be turned on and off in flight by a switch on the transmitter.
When stabilization is ON, the green Status light will be illuminated.
Stabilization ON/OFF Channel
By default, Stabilization ON/OFF is controlled by a switch assigned to CH7 (Aux2). To change this to CH5 (Gear),
proceed as follows:
1. On the transmitter, make sure a suitable switch is available on the desired channel.
2. With receiver OFF, place a Bind Plug on the channel 5 pins.
3. Press button C and hold while powering ON the receiver.
4. Release button C when all six LEDs flash (three red, three green).
5. The Setup lights briefly show which channel is being used currently: Green = CH7, Blue = CH5.
6. To change, tap button C.
7. Allow the receiver to exit from this mode and power OFF. Remove Bind Plug from channel 5 pins.
Turn on the receiver and test operation of the transmitter switch on the selected channel. The green Status light
should now show whether stabilization is ON or OFF.
4
Those familiar with the previous Lemon RX stabilized receivers will recognize that the green Stabilization Direction LEDs
are equivalent to DIP switches J1, J2, and J3, while the three red Programming LEDs correspond to J4, J5 and J6.