LENCO KCR-004 DAB+ - Troubleshooting

Error
Remedy
The device does not switch on.
Check if the power adaptor is connected properly with
power supply.
No sound
1. Turn on the sound as it may be muted.
2. Increase the volume.
Hiss in FM mode
1. Check/move the FM antenna.
2. Move the radio.
3. Draw out the wire antenna and try different direction.
No stations
available/burbling/intermittent in
DAB mode.
1. Move the radio.
2. Draw out the wire antenna and fix it in vertical
direction.
3. Rescan local stations only (high-strength).
4. Check the local DAB coverage.
Alarm does not work.
1. Switch on the alarm.
2. Due to the volume setting, refer to the solutions of “No
sound”.
Electro-Magnetic Interference.
The normal function of the product may be disturbed by
strong Electro-Magnetic Interference. If so, simply reset
the product to resume normal operation by following the
instruction manual. In case the function could not resume,
please use the product in other location.
All other undetermined cases.
Switch off, and then switch on again if necessary.