0906-E
8
LAN configuration
On the LAN network, each unit needs to be addressed:
• Unit n°1 ! Master unit
• Unit n°2 to 4 ! Slave units
For the configuration of each unit address on the LAN network, refer to DS50 Service display chapter.
Page 53 and above
Each DC 50 has to be addressed to its correspondent unit. In order to do so, please refer to DC50 Comfort Display page 43 and
above.
Both operations must be done without network connection (connector J11 on BM50).
If a unit has electronic expansion valves, the driver address must be corrected as explained in the correspondent chapter page
20 and above.
To Next Page
Loading...
