9
Installer Settings
Sets the thermostat for operation with either a heat
pump or condenser unit and defines the number of
compressor stages and the number of backup heat
stages (gas, electric or both).
system settings
compressor settings
indoor unit settings
no heat
<
non heat pump
heat pump
compressor stage
indoor heat stage
+
+
1
1
electric
gas/oil
Figure 4. System Setup
Sensors Settings
Use the following information to install sensors and
setup in the user interface.
Indoor Outdoor
outdoor sensor
indoor sensor
remote 10k
remote 20k
<
outdoor
discharge air
none
internal
Figure 5. Sensor Selections
To Next Page
Loading...
