Lennox iComfort 10F81

iComfort Wi-Fi
®
7-Day Programmable Communicating Thermostat
Page 21
1. Press and release Wi-Fi in the lower left corner of the HOME screen
indoor temperature
indoor humidity is 41%
fan is
OFF
9:39 am May 23, 2012
fan is
AUTO
cool-to
set temp
75
Heat-to
72
heat
or
cool
fan is
AUTO
enter
away
outdoor
temperature
80
system is cooling
Wi-Fi
Zone 1
?
1
Wi-Fi
Figure 34. Press Wi-FI
2. Press the Wi-Fi disable button to enable Wi-Fi.
WI-FIL SETTINGS
Press to enable /
disable Wi-FI
disabled
Thermostat is not connected to the Wi-FI network
WI-FI
X
Figure 35. Enable Wi-FI
3. The User Agreement screens will appear next. Press next as many
times as necessary; then press accept after reading the User
Agreement.
ESTABLISHING A WI-FI CONNECTIONS
There are two methods to setup your Wi-Fi connection. Select either
NETWORK SETTINGS or connection status.
Method 1 — Network Settings Method
1. Press NETWORK SETTINGS; this screen shows a graphical view of
buttons representing OPEN and SECURE Wi-Fi networks and a button
for adding a network.
WI-FI SETTINGS
press to enable /
disable Wi-FI
enabled
Thermostat is not connected to the Wi-FI network
WI-FI
X
NETWORK
SETTINGS
press to change
network settings
Must setup a network connection before registering thermostat
connection
status
Press to see
connection status
Figure 36. Enable Wi-FI
 Open connection which which requires no password.
 Secure connection which requires Wi-Fi password (security
key).
 Add a network is required when Wi-Fi identification (SSID) is
being hidden (not broadcasting). You will need to know the Wi-Fi
network name (SSID), security encryption type (if enabled), and
security password (if security encryption is enabled).
2. When selecting a:
 unsecured connection a screen will appear with two options,
connect and router info. Press connect to continue.
 secured connection a screen will appear requesting the Wi-Fi
network password (security key). There are two options to select
from which are connect and router info. Using the on-screen
keyboard, enter the password (security key) and then press
connect to continue.