Need help?Do you have a question about the Lennox iComfort S30 Smart Thermostat and is the answer not in the manual?
General| Display Type | Color touchscreen |
|---|---|
| Wi-Fi Connectivity | Yes |
| Bluetooth | No |
| Compatibility | Lennox HVAC systems |
| Energy Reports/Monitoring | Yes |
| Geofencing | Yes |
| Product Type | Smart Thermostat |
| Programmability | 7-day programmable |
| Humidification Control | Yes |
| Dehumidification Control | Yes |
| Ventilation Control | Yes |
| Remote Access | Yes |
| Installation | Professional installation recommended |
| Mobile App | Yes (iComfort App) |
| Voice Control | Amazon Alexa, Google Assistant |
| Power Source | 24V AC |
| Operating Modes | Heat, Cool, Auto |
| Alerts | Yes |
Instructions for installing the Smart Hub, emphasizing vibration minimization and mounting surfaces.
Guidance on positioning and adjusting the Smart Hub antennas for optimal performance.
Details on wire gauge, maximum run length, and terminal connections for Smart Hub.
Information on diagnosing issues using Smart Hub LED indicators and general troubleshooting rules.
Explains the function and behavior of the Smart Hub's center push button LED.
Defines terms like RSSI and lists potential Wi-Fi interference sources.
Details the voltage specifications for Smart Hub power input, output, and communication.
Explains how to group multiple Smart Hubs and their limitations.
Provides recommendations for mounting the Mag-Mount to a 2x4 electrical J-box.
Details wire gauge, run length, and terminal connections between Mag-Mount and Smart Hub.
Discusses troubleshooting the Mag-Mount, focusing on its blue LED status and possible causes.
Instructions for checking 12VDC on Mag-Mount terminals when the HD Display is removed.
Outlines the electrical interface pins for the HD Display connection to the Mag-Mount.
Steps to enable Smart Away directly on the S30 HD Display and set away set-points.
Instructions for enabling Smart Away using the mobile iComfort Thermostat application.
Guide for connecting the S30 Control System to a home wireless network.
Details the reasons and steps for creating a consumer account via the thermostat.
Instructions on adding multiple thermostats to an existing consumer account.
Explains how multiple thermostats appear on the system once connected.
Describes error messages and recovery process for power interruptions or signal issues.
Explains error messages and recovery related to electrical discharge events.
Instructions on how to reset the HD Display if the screen freezes or goes blank.
Explains how dealers can access customer accounts and systems using their portal.
Steps for dealers to enable remote viewing and control of customer systems.
Guide on creating a consumer account through the consumer portal website.
Instructions for adding a specific iComfort system to an existing consumer account.
Steps to remove a system by deleting the 'home' information from the account.
Steps to remove a system by using the 'move out' function in the account settings.
Lists the required operating system versions for the iComfort Mobile Setup application.
Detailed steps for commissioning a system using the iComfort Mobile Setup Application.
Alternative method to connect the mobile app to the Smart Hub via its own Wi-Fi.
Instructions for using the iComfort Mobile Setup Application as a service tool after commissioning.
Troubleshooting steps for when the mobile app cannot detect the Smart Hub.
Solves issues where the mobile device cannot connect to the Smart Hub.
Addresses Mag-Mount LED status and HD Display connection issues.
Provides steps to resolve issues where the HD Display screen freezes or becomes blank.
Explains how a mounting screw can interfere with the Mag-Mount and HD Display connection.
To Next Page