Page 40
START-UP REPORT
Job Name:___________________________________
Store No.___________Start-Up Date:______________
Address:_____________________________________
City:______________________________State:______
Start-Up Contractor:____________________________
Technician:___________________________________
Model No.:___________________________________
Serial No.:____________________________________
RTU No.:________ Catalog No.:__________________
Inspections and Checks
Damage? Yes No R22 R410A
If yes, reported to:____________________________
Verify factory and field-installed accessories.
Check electrical connections. Tighten if necessary.
Supply voltage: L1-L2______L1-L3_____L2-L3_____
If unit contains a 208-230/240 volt transformer:
Check primary transformer tap
Transformer secondary voltage: __________
Cooling Checks
Compressor Rotation Ambient Temp.________Return Air Temp.________ Supply Air Temp.________
Compressor Amps Compressor Volts Pressures Condenser Fan Amps CC Heater Amps
L1 L2 L3 L1-L2 L1-L3 L2-L3 Disch. Suct. L1 L2 L3 L1
1
2
3
4
Blower Checks
Pulley/Belt Alignment
Set Screws Tight
Blower Rotation
Belt Tension
Nameplate Amps:_________ Volts:_______________
Motor Amps
L1_________
L2_________
L3_________
Volts
L1-L2_____________
L1-L3_____________
L2-L3_____________
Heating Checks - Gas
Fuel type: Nat. LP Inlet Pressure:_____in. w.c.
Return Air Temp.:______ Supply Air Temp.:_____
Altitude:____________ Primary Limits Operate:
CO2%:
Gas Valve
Manifold Pressure
Low Fire High Fire
GV1
GV2
Control Type
Heating Checks - Electric
Return Air Temp.:______ Supply Air Temp.:______
Limits Operate:
Amps
L1 L2 L3 L1 L2 L3
1 10
2 11
3 12
4 13
5 14
6 15
7 16
8 17
9 18
Accessory Checks
Power Exhaust Amps
1 _____________ 2 ____________ None
Economizer Operation
Min. Pos. Motor travel full open/close
To Previous Page
Loading...
Need help?
General
