5
Figure 7. Wiring Connections MWMA/B
Figure 8. MWMA/B Receiver Board
CN 403
Connect to
controller
Receiver board
4-conductor shielded wire on the controller
Cable C
CN403
Cable A
NOTE - CN 403 is used to connect either the M0STAT64Q local controller OR a centralized control. It is not possible to connect
both the M0STAT64Q controller and a centralized control to this unit.
Factory-connected to
Display Board
Receiver board
Display board
4-core shielding wire on the controller
The connection cable A
CN1
CN40
X
Y
E
5V
White
Yellow
Brown
Red
The connection cable D
Figure 9. Wiring Connections MWMC
To Next Page
Loading...
