Lennox Wired Controller User Manual

9
• Mode button. Press to scroll
through the operation modes:
Auto → Cool → Dry → Heat → Fan.
• Timer ON button. Press to set the
number of hours of delay before the
indoor unit begins operation.
• Timer OFF button. Press to set the
number of hours of delay before the
indoor unit stops operation.
• Follow Me button. Press to activate
the controller’s air temperature sen-
sor. This transfers the temperature
sensing function from the indoor unit
to the controller. The indoor unit’s air
temperature sensor will be disabled.
• Reset button. Using a blunt-tipped
device (paper clip), press to cancel
current settings and reset remote con-
troller to factory settings.
• On/Off button. Press to turn the in-
door unit on or off.
• Up arrow button. Press to increase
the temperature setpoint or to scroll
through settings options.
• Down arrow button. Press to de-
crease the temperature setpoint or
scroll through settings options.
• Swing button. Press once to initiate
louver left & right oscillation. Press
again to stop louver oscillation. Lou-
vers remain in place where stopped.
Not available in all indoor unit models.
• Economy button. Not used.
• Fan speed. Press to scroll through
the fan speeds: Auto → Low → Med
→ High
• Lock button. Using a blunt-tipped
device (paper clip), press to lock or
unlock the current setting.

Lennox Wired Controller Specifications

General

Brand	Lennox
Model	Wired Controller
Category	Controller
Language	English