Hard disk drive in the internal storage drive bay
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
Attention: The internal storage drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data. When handling the internal storage drive, observe the following guidelines:
• Replace the internal storage drive only for repair. The internal storage drive is not designed for frequent
changes or replacement.
• Before replacing the internal storage drive, make backup copy of all the data that you want to keep.
• Do not touch the contact edge of the internal storage drive. Otherwise, the internal storage drive might get
damaged.
• Do not apply pressure to the internal storage drive.
• Do not make the internal storage drive subject to physical shocks or vibration. Put the internal storage
drive on soft material, such as a cloth, to absorb physical shocks.
For access, do the following:
1. Remove the side panel. See “Side panel” on page 61.
2. Disconnect the cable from the hard disk drive.
Chapter 7. Hardware removal and installation 67
To Next Page
Loading...
