Removal steps
Screw (quantity)
Color
Torque
M2 x 3 mm, Zn coated (1)
Black 1.5 ± 0.2 lb/in
Wi-Fi card adapter
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove the side panel. See “Side panel” on page 61.
2. Remove the CPU duct. See “CPU duct” on page 66.
3. Remove the Wi-Fi card. See “Wi-Fi card” on page 92.
Removal steps
Note: If your computer comes with a Wi-Fi card that supports the Bluetooth function, disconnect the
Bluetooth cable from the Wi-Fi card adapter.
Chapter 7. Hardware removal and installation 93
To Next Page
Loading...
