Rear Panel
1. Security Lock — Connect a security cable to prevent theft.
2. Power Button — Use the power button to power the EZ Media on and off.
3. USB Connector — Supports devices such as USB storage devices.
4. Gigabit Ethernet — High-speed Ethernet connector that will automatically detect your network speed
(10/100/1000Base-T).
5. Reset Button — Hold the RESET button for four seconds to reset security and network settings. This
allows you to regain access if network settings are incorrect or you've forgotten your password.
6. Power Connector — Plug the power cord into this connector.
Default Settings
● IP Address: If not DHCP server is found on your network, the EZ Media & Backup Center will
get a self-assigned IP address in the 169.254.x.x range.
● Device Name: The default name for your EZ Media & Backup Center is LenovoEZ. If there is
more than one EZ Media on your network, a number is added to the name, such as LenovoEZ-
1 LenovoEZ-2, and so on.
● Default Shares — Device setup will create default Shares on your EZ Media. The specific
default Shares will vary depending on the options you select during device setup. You can
create additional Shares as desired.
Setting up Your EZ Media & Backup Center
4 About the EZ Media & Backup Center Components
To Next Page
Loading...
