Connecting the EZ Media & Backup Center to Your
Network
Check Package Contents
Verify that the box contains the following items:
1. EZ Media (models may vary)
2. Power Adapter and Cord
3. Quick Start Guide
4. Ethernet Cable
Package contents may vary.
Connecting the EZ Media
If you have purchased more than one EZ Media, complete all steps on one device before setting up
additional devices.
1. Use the included network cable to connect the EZ Media to your network router, switch, or hub.
2. Use the included power adapter and cord to plug the EZ Media into a surge-protected power
source.
3. Your EZ Media should power on automatically.
4. Your EZ Media should power on automatically.
Setting up Your EZ Media & Backup Center
Connecting the EZ Media & Backup Center to Your Network 5
To Next Page
Loading...
