Creating Share Permissions for AD Users and Local Users
You can create access permissions for both AD and local users on any new or existing Shares on your
px12-400r. For more information, see adding Shares and managing Shares.
Switching to Workgroup Mode from Active Directory
Switching your px12-400r from AD mode to Workgroup mode will remove all AD users and groups,
including AD admin users, from the px12-400r.
1. Click the Domain Management icon to open the feature management page.
2. Click the switch to turn off Active Directory.
3. Click Apply.
4. If you are an AD administrator making this change, you will be required to log back into the device
as a local user. If there isn't a local administrator account on the px12-400r, device setup will run to
enable you to create a new administrator user.
Creating a new local administrator user through device setup will not affect other configuration
settings or content stored on the px12-400r. Local users and groups will not be changed.
Using Active Directory Domain
50 Managing Your px12-400r Network Storage with Local and Active Directory Users
To Next Page
Loading...
