1 Terminator 3 Power cable
2 SCSI adapter connector 4 Tape drive connector
To install a replacement SCSI tape drive in a 3.5-inch model server, complete the
following steps:
1. If you have not attached the space filler from the tape enablement kit to the
tape-drive assembly, do so now.
2. Remove the fan-bracket assembly.
3. Gently pull the tape drive SCSI and power cables out the front of the
tape-drive bay approximately 5 to 8 cm (2 to 3 in.).
4. Connect the cables to the back of the tape drive.
5. Push the tape-drive assembly into the bays, gently pulling the cables farther
into the server as you do so, until the tape-drive assembly stops.
6. Push the tray handle to the closed (locked) position.
Chapter 4. Removing and replacing server components 83
To Next Page
Loading...
