7. Make sure that the hook-and-loop fastener on the SCSI cable terminator 1 is
attached to the hook-and-loop fastener on top of the CD/DVD drive bay.
8. Make sure that the SCSI signal cable 1 is routed to the supported SCSI
adapter that is installed in slot 1 of the PCI-X riser-card assembly, as shown in
the following illustration. Make sure that the cable passes through the cable
clamp 2.
Important: Make sure that the cables avoid any fan connectors.
84 ThinkServer RD120 server Machine Types 6444, 6445, 6446, and 6447: Hardware Maintenance Manual
To Next Page
Loading...
