If the system-level diagnostics tests...
Then...
2. Verify that the log is cleared by entering
the following command: sldiag device
status [-dev devtype|mb|slotslotnum] The
following default response is displayed:
SLDIAG: No log messages are present.
3. Exit Maintenance mode by entering the
following command: halt
4. Enter the following command at the
Loader prompt to boot the storage
system: boot_ontap
You have completed system-level diagnostics.
After you finish
If the failures persist after repeating the steps, you need to replace the hardware.
124
ThinkSystem DM3000x and DM5000x Hardware Installation and Maintenance Guide
To Next Page
Loading...
