Lenovo ThinkSystem HR650X - Page 46

©
Copyright
L
enovo
201
7
46
Type/Emulation.
Bits per
second
9600/1920
0/57600/11
5200
Selects serial port transmission speed. The speed
must be matched on the other side. Long or noisy
lines may require lower speeds.
Flow
Control
None/Hard
ware
RTS/CTS
/Software
Xon/Xoff
Flow control can prevent data loss from buffer
overflow. When sending data, if the receiving
buffers are full, a 'stop' signal can be sent to stop
the data flow. Once the buffers are empty, a 'start'
signal can be sent to re-start the flow. Hardware
flow control uses two wires to send start/stop
signals.
Data Bits
8
Parity None
Stop Bits
1
PCI SubsystemSettings Table(Sub of
Advanced Menu
)
PCI SubsystemSettings
PCI, PCI
-
X and PCI Express Settings.
PCI Bus Driver Version
A5.01.11
One Blank line
PCI Devices Common Settings:
Above 4G Decoding Disabled/Enabled Enables or Disables 64bit capable Devices to be
Decoded in Above 4G Address Space (Only if
System Supports 64 bit PCI Decoding).
SR-IOV Support Disabled/Enabled If system has SR-IOV capable PCIe Devices, this
option Enables or Disables Single Root IO
Virtualization Support.
Network Stack Configuration Table(Sub of
Advanced Menu
)
Network Stack Configuration
Network Stack Settings
Network Stack Disabled/Enabled Enable/Disable UEFI Network Stack
Ipv4 PXE Support Disabled/Enabled Enable Ipv4 PXE Boot Support. If disabled IPV4 PXE
boot option will not be created
Ipv4 HTTP Support Disabled/Enabled Enable Ipv4 HTTP Boot Support. If disabled IPV4
HTTP boot option will not be created