3 minutes/4 minutes/5 minutes/6
Enter value Between 3 to 6 min
Do Nothing/Reset/ Power
Down/Power Cycle
Configure how the system should
respond if the FRB-2 Timer
expires. Not available if FRB-2
Enabled/Disabled
If enabled, starts a BIOS timer
which can only be shut off by
Intel Management Software after
the OS loads. Helps determine
that the OS successfully loaded or
follows the OS Boot Watchdog
5 minutes/10 minutes/15
minutes/20 minutes
Configure the length of the OS
Boot Watchdog Timer. Not
available if OS Boot Watchdog
Do Nothing/Reset/ Power
Down/Power Cycle
Configure how the system should
respond if the OS Boot Watchdog
Timer expires. Not available if OS
Boot Watchdog Timer is disabled.
Enabled/Disabled
Press <Enter> to enable or disable
Serial Mux configuration.
#In BMC DNS Configuration Table
Press <Enter> to Configure BMC
#In System Event Log Table
Press <Enter> to change the SEL
#In BMC self test Log Table
logs the report returned by BMC
self test command
#In View FRU Information Table
Press <Enter> to view FRU
information.
BMC network configuration
#In BMC network configuration
Table
Configure BMC network
parameters
#In View System Event Log Table
Press <Enter> to view the System
Event Log Records.
#In BMC User Settings Table
Press <Enter> to Add, Delete and
Set Privilege level for users.
#In SOL Configuration Parameter
Table
Press <Enter> to Configure SOL
Configuration Parameters.