Lenovo ThinkSystem SD530 V3 - Page 32

Figure 2. Front view of the ThinkSystem SD530 V3 node
Table 9. Components in the front view of the ThinkSystem SD530 V3 node
1 E3.S drive bay
6 External diagnostic handset connector
2 Drive activity LED
7 Front operator panel buttons and LEDs
3 Drive status LED
8 USB 3.2 Gen 1 (5 Gbps) connector
4 Pull-out information tab
9 VGA connector
5 Serial connector
1 E3.S drive bays
• Install E3.S drives or drive fillers to these bays (see “Drive replacement” in the User Guide or Hardware
Maintenance Guide).
• For more information about the drive LEDs, see “Drive LEDs” on page 31.
2 & 3 Drive activity LED & Drive status LED
For more information about the drive activity and status LEDs, see
“Drive LEDs” on page 31.
4 Pull-out information tab
This tab contains below information:
• Network information such as MAC address and XCC network access label.
• Drive bay numbers.
For more information about this tab, see
“Identify the system and access the Lenovo XClarity Controller” on
page 47
.
5 Serial connector
Connect a 9-pin serial device to this connector.
6 External diagnostic handset connector
Connect the external diagnostics handset to this connector.
For more details, see
“External Diagnostics Handset” on page 37.
22
ThinkSystem SD530 V3 System Configuration Guide