Lenovo ThinkSystem SD530 - Page 39

POST Attempts
Item Options Description
Post Attempt Limit
• Disable
• 9
• 6
• 3
Configure the number of attempts to POST before the
recovery mechanism is invoked. When the number of
consecutive failed POST attempts reaches the limit, the
system will reboot with the factory default settings. 3 is
the default setting.
Note: You may encounter some message boxes when post attempts. Follow the message for setup.
Advanced RAS
Item Options Description
Machine Check Recovery
• Enable
• Disable
Enable software layers (OS, VMM, DBMS, Application) to
assist in system recovery from hardware uncorrectable
error. Enable is the default setting.
PCI Error Recovery
• Enable
• Disable
Allow the system to recover from an uncorrectable PCIe
fault when enabled. The faulting PCIe device will be
disabled for error containment and the OS will be notified
to rescan the PCIe buses. Disable is the default setting.
An uncorrectable PCIe fault will result in an NMI when
disabled.
PCIe Endpoint Reset on Fatal
Error
• Enable
• Disable
PCIe Endpoint Reset On Fatal Error. Disable is the default
setting.
Chapter 3. System configuration and boot management 35