Table 15. User security details (continued)
Clear Power-On Password N/A Clear the Power-On password.
Note: Click the button, pop-up message box will show
up.
• Power-On Password is not set
Press Enter to Continue
• An existing Power-On Password will be deleted.
<ENTER> Continue. <ESC> Return to Setup Utility
• Power-On Password has been cleared successfully
Press Enter to Continue
Set Administrator Password N/A Set the Administrator password.
The password can only contain the following characters
(no white-space characters allowed): A-Z, a-z, 0-9, ~`!@#$
%^&*()-+={}[]|:;"'<>,?/.\_
Must contain at least one letter
Must contain at least one number
Must contain at least 2 of the following combinations:
• At least one upper-case letter
• At least one lower-case letter
• At least one special character
No more than 2 consecutive occurrences of the same
character
Must be at least 8 characters if doesn’t select other value
in “Minimum password length” option.
Notes: Clicking the button, pop-up message box will
show up.
• Please type in your password
• Please type in your new password
• Please confirm your new password
• Administrative Password has been set successfully
• The password failed to meet the “Minimum password
reuse cycle” requirements.
• The password can’t be changed because the
“Minimum password change interval” time is not
exceeded.
• The password does not meet the minimum password
complexity requirements.
Please check the help for “Set Power-On Password” or
“Set Administrator Password” settings.
• Please enter enough characters
Press Enter to Continue
52 ThinkSystem Server with Intel Xeon SP (1st, 2nd Gen) UEFI Manual
To Next Page
Loading...
