EasyManua.ls Logo

Lenovo ThinkSystem SR550 - Page 54

Lenovo ThinkSystem SR550
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 15. BMC settings settings (continued)
Ethernet over USB interface
• Enable
• Disable
[Enable] for using the xClarity Essentials in-band update
utility. [Disable] will prevent xClarity Essentials and other
applications that are running on the server from
requesting the BMC to perform tasks.
Network Settings N/A Configure the network of the management controller.
Reset Factory Defaults Setting N/A Restore all management controller settings to factory
defaults, including network configuration and credentials,
the management controller will be restarted automatically.
Restart BMC N/A Restart the BMC.
Network settings
Item
Options
Description
Network Interface Port
• Dedicated
• Shared
Select the System Management Network Interface Port.
Note: This option is configuration dependent.
Shared NIC on
1. ML2 Card
2. PHY Card
3. Onboard Port 1
Select the shared NIC port.
Note: This item is only on when network interface port is
on Shared, and this option is configuration dependent.
Fail-Over Rule
• None
• Failover to shared
(Optional Card
ML2)
• Failover to shared
(Optional Card
PHY)
• Failover to shared
(Onboard Port)
Setting to control Fail-Over types allowed.
Note: This item is only on when Network Interface Port is
set to [Dedicated], and this option is configuration
dependent.
Network Setting
• Synchronization
• Independence
The item will be selectable when Fail-Over Rule enabled
to onboard port or optional card. Please setup the share
mode network settings after changing “Synchronization”
to “Independence” in NIC failover mode.
Burned-in MAC Address N/A
Hostname
N/A Change the host name. The new name should be within 1
to 63 characters.
DHCP Control
• Static IP
• DHCP Enabled
• DHCP with
Fallback
Configure DHCP Control or manually configure a static IP
address. Fallback will use static IP address if DHCP fails.
Select Static to enter IPV4 address manually.
IP Address
x.x.x.x
Enter IP address in dotted-decimal notation.
When entering an invalid IP address:
• ERROR
• Invalid Input Range
• Ok
50 ThinkSystem Server with Intel Xeon SP (1st, 2nd Gen) UEFI Manual