LZV100 Command/Power Station 23
Isolate both rails of the track at the junction of the single supply
areas and make sure the polarity is the same.
If you are operating locomotives with offset pickups (common in
HO scale brass steam locomotives), the you will need a common
between the power stations. See “Layout Wiring considerations”
later on in this manual. " (
Öp. 28).
8.3 Adding a Layout Feedback Bus
The LZV100 provides the capability for utilizing a layout feedback
bus. This bus is used to interconnect sensors on the layout and is
used for block occupancy, signaling, and other forms layout
automation. A computer connected through an LI100F is normally
used to gain full advantage of this capability.
8.4 Using RailCom
RailCom is an advanced form of communication between
decoders and your control system. This will allow exciting new
capabilities in the future. There are no special wiring requirements
to utilize RailCom with your LZV100 as the necessary components
are built into the system.
To Next Page
Loading...