LZV100 Command/Power Station 25
) Make sure that you do not mix up the cables of the
terminals L and M. This could result in a short in the
connected input devices.
If you are upgrading from a Set-02 you may replace the coil cord
on the LH200 you used as the command station with a coil cord
that has a 5-pin din connector. The DIGITAL plus part number for
the cord is LY006.
9.2 Using Modular Plugs
You may use Module plugs instead of DIN plugs for wiring your
XpressNet or any combination of Din and Module plugs.
Figure 9: Module Plug Wiring
Pin # Port A Port B Description
Pin 1 White N/C
Optionally “C”
Pin 2 Black Black
Ground "M"
Pin 3 Red Red
- RS-485 "B"
Pin 4 Green Green
+ RS-485 "A"
Pin 5 Yellow Yellow
+12 volts "L"
Pin 6 Blue N/C
Optionally :”D”
If you use module plugs you can use either 4 or 6 wire plugs.
) If you are upgrading from Set-02 you must remove the
module plug connection to your LV100 or LV200 and instead
connect your LH200 to the LZV100's XpressNet.
To Next Page
Loading...