Lenz Digital plus - Controlling Points and Signals

32
7 Switching points and signals
To select a point address, follow these simple steps:
1.
"Answer" (if you are not already in the control mode for
locomotives).
2. Press "Hash".
3.
...
Enter point address. The permitted range is 1 to 1024.
4. Press "Hash".
5.
, ,
Switch point to "-".
or
, ,
Switch point to "+".
6.
Return to the control mode for locomotives with the number
controlled last or
Select a new point address (then continue with Step 3)
Press “0“ to trigger an emergency stop or emergency shutdown whilst switching
points.