Lenz Digital Plus LS150 User Manual

Accessory decoder LS150 1
The DIGITAL plus LS150 turnout decoder provides cost effective turnout control for
up to 6 independent turnouts.
∗ Suitable for twin-coil snap action switch machines
∗ Suitable for motorized switch machines
∗ High current provision to support Peco and Atlas switch machines
∗ The 6 turnout addresses can be sequential or up to 6 user selected
addresses.
∗ Control using separate push-buttons possible.
∗ Configuring the LS150 does not require a separate programming track and the
parameters can be changed at any time in the future even after installation.
LS150
Turnout Decoder for up to 6
independent turnouts
Art. No. 11150
December 2003
Submitted to the NMRA for
C&I testing

Lenz Digital Plus LS150 Specifications

General

Compatibility	DCC
Power Supply	16V AC
Current Output	1.5A
Voltage Output	16V AC
Programming Modes	Operations Mode
Display	No

Summary

LS150 Turnout Decoder Introduction

Important Advice and Safety

Use of the LS150

Technical Data

LS150 Outputs

Power and DCC Signal Inputs

Connecting the LS150

AC Power Supply Connection

Connect the decoder to an AC transformer, observing voltage and power limits for safe operation.

DCC System Connections

NMRA DCC Digital System Connection

Connect the LS150 to the track output of the digital system (terminals J, K).

Twin-Coil Switch Machine Connection

Connect twin-coil switch machines to the LS150 outputs, managing coil polarity for correct operation.

Motorized Switch Machine Connection

Push-Button Control

Controlling the Outputs

Setting Decoder Addresses

Sequential Address Setting

Set the first output address; others automatically follow sequentially for simpler configuration.

Individual Address and Pulse Duration Setting

Configure each output with unique addresses and adjustable pulse durations from 0.1 to 10 seconds.

Resetting the Decoder

North American Warranty