Program structure
MA8201BB 2.0l -3-
Program structure
The program consists of three levels. The frequency inverter is parameterized in the code
level and the parameter level:
Operating level Code level Parameter level
The frequency inverter is in
the operating level after
every mains connection.
The switch-on display (C004)
is displayed.
Change to the code level
using the PRG key.
Selectacodebypressing▲
or ▼ in the code level.
Change to the parameter
level using the SH key.
The parameter level contains
two parameter sets, PAR1
and PAR2. You c an change
from PAR1 to PAR2 using the
SH key.
Every code contains para-
metersusingwhichyoucan
parameterize your drive.
The flashing of ’PAR1’ or
’PAR2’ indicates in which
parameter set you are
current working.
P A R 1
H z
S E T
.
H z
S E T
.
S H
S H
P R G
%
A
H z
.
S H
S H S H
P R G
P R G
D i s p l a y v a l u e
C h a n g e v a l u e
S a v e v a l u e
1 s
C o d e l e v e l
P A R 1 o r P A R 2 b l i n k i n g ,
w h e n c h a n g e a b l e
C o n t r o l l e r
i m h i b i t e d
S e t p o i n t
c h a n g e d i f
C 0 0 1 = 1
C o n t r o l l e r
e n a b l e d
1 s
1 s
P a r a m e t e r l e v e l
O p e r a t i n g l e v e l
S e l e c t
c o d e
P A R 2
P A R 1
P A R 2
S e t p o i n t
c h a n g e d i f
C 0 0 1 = 1
To Next Page
Loading...
