Maintenance
Repair
Changing the fan
6
59
LDCDS-CPC9100 DE/EN 1.0
6.2.2 Changing the fan
Note!
The fan is hot-swappable which means that it can be changed during
operation.
3
0
1
2
CPC9100-010
How to change the fan:
1. Open the housing ( 58).
If you change the fan during operation, observe the following:
– Do not touch any current-carrying parts.
– Do not touch any rotating fan blades (risk of injury!).
– Make sure that no small parts fall into the device which would cause a short
circuit.
– Carry out the works i mmediately and without any interruptions.
2. Unscrew the screw and remove the fan housing cover .
3. Pull the fan out upwards and replace it by a new one. When inserting the new fan,
make sure that the spring contacts of the fan connection are bottom right (pos. ).
4. Place the fan housing cover on the housing again and tighten the screw .
5. Close the housing ( 58).
To Next Page
Loading...
