Code table
10
Function library
10.20
L
10.20-30
EDS82EV903-1.0-11/2002
Code IMPORTANTPossible settings
No. SelectionLenzeName
C0412
v
(cont.)
Analog signal sou rce pos s ible for C0412
^ 10.12-1
0 Not assigned (FIXED-FREE) or selected via keypad
or parameter channel of an AIF bus module
1 Analog input 1 (AIN1-OUT)
X3/8 (Standard-I/O)
X3/1U or X3/1I (Application-I/O)
2 Frequency input (DFIN1-OUT) Observe C0410/24, C0425, C0426, C0427
3 Motor potentiometer (MPOT1-OUT)
4(A) Analog input 2 (AIN2-OUT)
X3/2U or X3/2I
5 ... 9 Input signal is constantly 0 (FIXED0)
10 AIF input word 1 (AIF-IN.W1)
Only evaluated if C0001 = 3!
11 AIF input word 2 (AIF-IN.W2)
20 CAN-IN1.W1 or FIF-IN.W1
± 24000 ≡ ±480 Hz
21 CAN-IN1.W2 or FIF-IN.W2
2
14
≡ 100 % rated motor torque
22 CAN-IN1.W3 or FIF-IN.W3
23 CAN-IN1.W4 or FIF-IN.W4
30 CAN-IN2.W1
31 CAN-IN2.W2
32 CAN-IN2.W3
33 CAN-IN2.W4
200 Signals are assigned word by word from fieldbus
function module to FIF (e.g. INTERBUS or
PROFIBUS-DP)
See C0005
228 (A) PCTRL1-ACT
229 (A) PCTRL1-SET
230 (A) PCTRL1-OUT
231 (A) NSET1-RFG1-IN
232 (A) NSET1-NOUT
233 (A) PCTRL1-PID-OUT
234 (A) PCTRL1-NOUT
255 Not assigned (FIXED-FREE) or selected via keypad
or parameter channel of an AIF bus module
Either NSET1-N1 or NSET1-N2 active
C0413* Offset analog inputs The max. limit of the setpoint value range
of C0034 equals 100 %
^ 10.8-3
1 AIN1-OFFSET 0.0
-200.0 {0.1 %} 200.0
Settings for X3/8 and X3/1U, X3/1I
C0413/1 a nd C0026 a re identical
2 AIN2-OFFSET 0.0 Setting for X3/2U, X3/2I
(application I/O only)
C0414* Analog input gain • 100.0 % = Ga i n 1
• Inverse setpoint selection by negative
gain and negative offset
1 AIN1-GAIN 100.0
-1500.0 {0.1 %} 1500.0
Settings for X3/8 and X3/1U, X3/1I
C0414/1 a nd C0027 a re identical
2 AIN2-GAIN 100.0 Sett ing fo r X3/2U, X3/2I
(application I/O only)
To Next Page
Loading...