Lenze E94ASHE Series - Page 82

Wiring the device modules
Safety modules
6

82
EDK94SH104 ZH/EN 5.1
X82.3 Labelling Description
GCL
GND clock output
GI2
GND IN I2A/I2B
I2B
Sensor input 2, channel B (only for passive sensors)
I2A
Sensor input 2, channel A (only for passive sensors)
GCL
GND clock output
GI1
GND I1A/I1B
I1B
Sensor input 1, channel B (only for passive sensors)
I1A
Sensor input 1, channel A (only for passive sensors)
n. c. This terminal is not assigned.
X82.4 Labelling Description
GCL
GND clock output
GI4
GND I4A/I4B
I4B
Sensor input 4, channel B (only for active sensors)
I4A
Sensor input 4, channel A (only for active sensors)
n. c.
This part of the terminal strip is not assigned.
Sensor input 3 is not available.
n. c.
n. c.
n. c.
n. c.
Cable cross−sections and tightening torques
Type [mm
2
] [Nm] AWG [lb−in]
Wire end ferrule,
insulated
0.25 ... 0.75
Spring terminal
24 ... 18
Spring terminal
Rigid
0.14 ... 1.5 26 ... 16
Stripping length or contact length: 9 mm