What to do if Lenze ESMD371X2SFA shows short-circuit or overload?
If the Lenze Inverter displays a short-circuit or overload error, this is likely due to a short-circuit condition. To resolve this, identify the cause of the short-circuit and inspect the motor cable.
Why Lenze ESMD371X2SFA Inverter displays undervoltage on DC bus?
If you're seeing an undervoltage error on the DC bus of your Lenze Inverter, the mains voltage may be too low. Verify that the mains voltage is within the acceptable range.
How to fix motor overload (I2t overload) on Lenze ESMD371X2SFA Inverter?
If the Lenze Inverter indicates a motor overload (I2t overload), the motor is likely overheating due to an impermissible continuous current or frequent/lengthy acceleration. Address this by checking the controller selection and the setting of c20.
What causes external error on Lenze Inverter?
If your Lenze Inverter is showing an external error, it means the digital input “TRIP set” is active. To resolve this, you should remove the external error.
How to deactivate DC-injection brake on Lenze ESMD371X2SFA?
The DC-injection brake may be active on your Lenze Inverter because it was activated via digital input or automatically. To deactivate it, ensure the digital input is LOW, or wait for it to deactivate automatically after the holding time c06 has expired.
What to do if Lenze ESMD371X2SFA Inverter shows EPM error?
If your Lenze Inverter displays an EPM error, the EPM is either missing or defective. Power down the Inverter and replace the EPM.
Why Lenze ESMD371X2SFA Inverter shows digital inputs not uniquely assigned?
If the Lenze Inverter indicates that digital inputs are not uniquely assigned, this means that E1...E3 are assigned with the same digital signals. Ensure that each digital signal is only used once.
Why automatic start inhibited on Lenze Inverter?
If automatic start is inhibited on your Lenze Inverter, it is because c42 = 0. Apply a LOW-HIGH signal change at terminal 28.
How to solve Lenze Inverter stop with inhibited outputs U, V, W?
If the Lenze Inverter has stopped and outputs U, V, and W are inhibited, this is due to a LOW signal at terminal 28. Set terminal 28 to HIGH.
Why Lenze ESMD371X2SFA output frequency is 0 Hz?
If the output frequency of your Lenze Inverter is 0 Hz and outputs U, V, W are inhibited, the setpoint is likely 0 Hz (C31 = 0). Perform setpoint selection.
Explains symbols used for warnings and notes to ensure safe operation and understanding of potential hazards.
Details compliance with directives, environmental conditions, and application limitations.
Lists electrical specifications including power, voltage, current, and frequency for various models.
Covers physical mounting, dimensions, and environmental constraints for installing the drive.
Details wiring, EMC requirements, fuses, and cable cross-section specifications.
Visual guide for power and control wiring connections to the inverter.
Explains the purpose, function, and configuration of each control terminal.
Guide to navigating and changing operational parameters for the inverter.
Information on the EPM for storing and managing parameter settings, and optional programmers.
Detailed listing and explanation of available configuration codes and their settings.
General| Power Rating | 0.37 kW |
|---|---|
| Protection Class | IP20 |
| Control Method | U/f control |
| Cooling Method | Air Cooling |
| Communication Interface | RS485 |
To Next Page