EasyManua.ls Logo

Lenze EVF8212-EV020 - Page 8

Lenze EVF8212-EV020
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety information
2-2 821XKlimaBA0399
cases for drive controllers with the CE mark. The compliance with the required limit values demanded by the EMC
legislation is the responsibility of the manufacturer of the system or machine.
6. Operation
Systems where drive controllers are installed must be equipped, if necessary, with additional monitoring and protective
devices according to the valid safety regulations, e.g. law on technical tools, regulations for the prevention of
accidents, etc. Modifications of the drive controllers by the operating software are allowed.
After disconnecting the drive controllers from the supply voltage, live parts of the controller and power connections
must not be touched immediately, because of possibly charged capacitors. For this, observe the corresponding labels
on the drive controllers.
During operation, all covers and doors must be closed.
7. Maintenance and servicing
The manufacturer’s documentation must be observed.
This safety information must be kept!
The product-specific safety and application notes in these Operating Instructions must also be
observed!
Show/Hide Bookmarks

Table of Contents

Related product manuals