Lenze i510 - Default Control Setup

To Next Page

To Previous Page

Operating instructions i510 cabinet frequency inverter | 21

Networks

Network CANopen Modbus RTU

Connection X216

Connection type Spring terminal, pluggable

Max. cable cross-section mm² 2.5

Stripping length mm 10

Required tool



0.4 x 2.5

CANopen / Modbus RTU

Select network CANopen or Modbus RTU using the switch on the front of the inverter.

The network must be terminated with a 120Ω resistor at the physically rst and last node.

Connect the resistor to terminals TB/CH and TA/CL.

• Node address = setting in P510.01

• Baud rate = setting in P510.02

• For Modbus RTU, the baud rate and parity are detected automatically.

Electrical installation



















3-phase | 480 V

3-phase | 230/240V

3-phase | 400 V

1-phase | 230/240V

Control terminals

Relay outputConnection diagramPreparation Networks

Other manuals for Lenze i510