Need help?Do you have a question about the Lenze I51AE175B and is the answer not in the manual?
Guidelines for preventing personal injury and material damage, including product usage and handling.
Identifies potential hazards like electrostatic discharge, electrical voltage, hot surfaces, and motor residual movement.
Specifies intended use, compliance with directives, and requirements for personnel qualifications.
Details on connecting the inverter to single-phase and three-phase power supplies.
Critical warnings about incorrect wiring and settings during commissioning.
Explains how to adapt the inverter to the drive task by changing parameters.
Explains error types, configuration, reset procedures, and keypad error messages.
Details on setting the rated mains voltage for proper inverter operation.
Defines motor parameters that characterize its electrical behavior.
Supports various modes like V/f, sensorless vector, and synchronous motor control.
Includes monitoring functions for overload, current limits, phase failure, and speed.
Covers PID controller basic settings, including operating mode and analog input configuration.
Commands for organizational functions like saving, loading, and resetting parameters.
Explains DC braking function for motor control, including automatic and manual activation.
Covers write access protection via keypad and EASY Starter for parameter security.
Manages the holding brake for low-wear control, including automatic and manual release.
Allows deceleration of the motor using rotational energy during power failure.
Details the configuration of up to 8 segments and one end segment for sequences.
Describes how to configure 8 sequences, each with 16 steps.
Covers enabling the sequencer, setting operating modes, end modes, and start modes.
Details configuration of triggers for basic motor control functions like start, stop, and reverse.
Lists and explains all inverter error messages, including causes and remedies.
To Next Page
General
