What to do if Lenze Inverter motor is too hot?
If the Lenze Inverter motor is too hot, verify that the motor data is correctly parameterized. If needed, adapt the motor and encoder parameters in inverter i500.
Why is my Lenze Inverter vibrating?
Vibrations in the Lenze Inverter can be caused by an insufficiently balanced flywheel or loose fixing screws. Rebalance the flywheel and check and tighten all screw connections.
Defines the intended use and limitations of the inverter product.
Crucial safety precautions for safe operation and to prevent injury.
Illustrates exemplary connection diagrams for voltage and power classes.
Terminal data and fusing for single-phase 230/240 V mains connection.
Terminal data and fusing for three-phase 230/240 V mains connection.
Terminal data and fusing for three-phase 400 V mains connection.
Terminal data and fusing for three-phase 480 V mains connection.
Steps for rapid commissioning using terminal control and parameter settings.
Lists error codes, their descriptions, classification, and remedies.
Defines the intended use and limitations of the inverter product.
Crucial safety precautions for safe operation and to prevent injury.
Illustrates exemplary connection diagrams for voltage and power classes.
Terminal data and fusing for single-phase 230/240 V mains connection.
Terminal data and fusing for three-phase 230/240 V mains connection.
Terminal data and fusing for three-phase 400 V mains connection.
Terminal data and fusing for three-phase 480 V mains connection.
Steps for rapid commissioning using terminal control and parameter settings.
Lists error codes, their descriptions, classification, and remedies.
General| Product Category | Inverter |
|---|---|
| Series | i500 |
| Protection Class | IP20 |
| Safety | STO (Safe Torque Off) |
| Control Method | V/f control |
| Communication Interfaces | CANopen, EtherCAT, PROFIBUS, PROFINET |
| Operating Temperature | -10°C to +50°C |
| Overload Capacity | 150% for 60 seconds |
| Frequency Range | 0-650 Hz |
| Protection Features | Overcurrent, overvoltage, undervoltage, overtemperature, short circuit |
| Cooling Method | Fan-cooled |
To Next Page
