What to do if Lenze Inverter motor is too hot?
If the Lenze Inverter motor is too hot, verify that the motor data is correctly parameterized. If needed, adapt the motor and encoder parameters in inverter i500.
Why is my Lenze Inverter vibrating?
Vibrations in the Lenze Inverter can be caused by an insufficiently balanced flywheel or loose fixing screws. Rebalance the flywheel and check and tighten all screw connections.
General| Product Category | Inverter |
|---|---|
| Series | i500 |
| Protection Class | IP20 |
| Safety | STO (Safe Torque Off) |
| Control Method | V/f control |
| Communication Interfaces | CANopen, EtherCAT, PROFIBUS, PROFINET |
| Operating Temperature | -10°C to +50°C |
| Overload Capacity | 150% for 60 seconds |
| Frequency Range | 0-650 Hz |
| Protection Features | Overcurrent, overvoltage, undervoltage, overtemperature, short circuit |
| Cooling Method | Fan-cooled |
To Next Page
