1. Safety instructions
1.1. Basic safety instructions
• Only qualified skilled personnel are permitted to work with or on Lenze drive and automation
components. According to IEC 60364 or CENELEC HD 384, these are persons …
… who are familiar with the installation, assembly, commissioning and operation of the product,
... possess the appropriate qualifications for their work,
... and are acquainted with and can apply all the accident prevent regulations, directives and
laws applicable at the place of use.
• The product ...
... must only be used for the purpose for which they are intended.
... must never be operated if noticeably damaged.
... must never be technically altered.
... must never be operated unless completely assembled.
... can be live during and after operation – depending on their degree of protection – and can al-
so have moving or rotating parts. Surfaces can be hot.
• When transporting the teachware, bear in mind the higher centre of gravity. Danger of the
teachware falling over.
• The trolley of the teachware is made for even base. Please use outdoors or on uneven surfaces
in indoor areas always additional suitable resources for the transport.
• Check and, if necessary, adapt the parameterization of motor data, encoder data and monitoring
settings (I²xt, temperature sensor) before operating the motors (especially external motors via
Speedtec connector).
• The regular technical inspections and replacement/repairment may only be carried out by suita-
bly qualified personnel (e.g. electricians). All technical alterations in the teachware are prohibit-
ed.
• Observe all instructions in this manual and in the documentation of the assembled controller,
inverters and motors. This is the precondition for safe and trouble-free operation and for obtain-
ing the specified product features.
To Next Page
Loading...
