Lenze i500 Series

16
Commissioning
Operang Instrucons i510-Cabinet
7.1.3 Quickcommissioning-terminalcontrol
The following quick overview with graphical parameter representaon is sucient for
commissioning many applicaons with terminal control. Further seng opons are described
in this document or in the commissioning document.
1. Load default seng = set P700.01 to 1.
2. Set the following parameters for V/f characterisc control:
• Mains voltage P208.01
• V/f characterisc data: Base voltage P303.01
• V/f characterisc data: Base frequency P303.02
• Minimum frequency P210.00
• Maximum frequency P211.00
• Acceleraon me 1 P220.00
• Deceleraon me 1 P221.00
• Analog input 1: Min frequency value P430.02
• Analog input 1: Max frequency value P430.03
3. Press
and hold the key for longer than 3 seconds to save the sengs.
7.1.1 Funconsofthekeys
Key Actuaon Acon
Press briey • Navigate in the Menu Change parameters
Press briey • Go to Menu/Parameters Conrm parameters
Press and hold for 3s • Save parameters
• “P.SAVED” in the display indicates that the parameters have been saved
Press briey Quit Menu/Parameters
Press briey Acvate keypad control
Press briey Start motor
Press briey Change rotang direcon
Press briey Stop motor
The motor must be at standsll before parameters can be changed or conrmed.
The sengs are saved temporarily unl the motor is switched o again. Press
and hold the
key for 3 s to save the sengs permanently.
7.1.2 Example of the keypad handling
Example for DO1 funcon assignment with parameter P420.02.
GROUP 4
P420.XX
P420.02
I/O setting
Fct. dig. outputs
DO1 funcon
P211.00
P430.03
P430.02 P430.02
P220.00
P221.00
P210.00
AI1
Time
Frequency