Lenze i55AE125B User Manual

Parameter Name / value range / [default seng] Info
0x2389:001
(P517.01)
PROFINET error: Error 1
(PROFINET error: Error 1)
•
Read only
•
From version 02.00
The parameter currently contains the error detected on the network.
•
The error values may occur in combinaon with the error values from
parameter 0x2389:002 (P517.02).
0 No error
1 Reserved
2 Unit ID unknown
3 Max. units exceeded
4 Invalid size
5 Unit type unknown
6 Runme plug error
7 Invalid argument
8 Service pending
9 Stack not ready
10 Command unknown
11 Invalid address descriptor
0x2389:002
(P517.02)
PROFINET error: Error 2
(PROFINET error: Error2)
•
Read only
•
From version 02.00
The parameter currently contains the error detected on the network.
•
The error values may occur in combinaon with the error values from
parameter 0x2389:001 (P517.01).
Bit 7 IP address error The IP address is invalid. Valid IP addresses are dened according to RFC
3330.
Bit 8 Staon name problem The staon name must be assigned according to the PROFINET specica-
on.
Bit 9 DataExch le
Bit 10 Stack boot error
Bit 11 Stack online error
Bit 12 Stack state error
Bit 13 Stack revision error
Bit 14 Inializaon problem
Bit 15 Stack init error The stack cannot be iniated with the user specicaons. A reason
might be, e. g., a staon name that does not correspond to the PROFI-
NET specicaon.
Related topics
4PROFINET ^ 365
6.2.4.6 EtherCAT diagnoscs
The following parameters serve to diagnose the EtherCAT interface and the communicaon
via EtherCAT.
Precondions
The control unit (CU) of the inverter is provided with EtherCAT (from rmware 02.00).
Parameter Name / value range / [default seng] Info
0x1000 Device type
•
Read only
•
From version 02.00
CANopen device prole according CANopen specicaon CiA 301/
CiA 402.
0x1008 Manufacturer device name
•
Read only
•
From version 02.00
Display of the manufacturer device name.
0x1009 Manufacturer hardware version
•
Read only
•
From version 02.00
Display of the manufacturer hardware version.
0x100A Manufacturer soware version
•
Read only
•
From version 02.00
Display of the manufacturer soware version.
0x1018:001 Identy object: Vendor ID
•
Read only
•
From version 02.00
Display of the manufacturer's idencaon number.
Diagnoscs and fault eliminaon
Diagnoscs parameter
Network diagnoscs
127

Lenze i55AE125B Specifications

General

Brand	Lenze
Model	i55AE125B
Category	Inverter
Language	English