Lenze m550-H-P63 80 Series - Page 35

At threaded pitch circle
1.
Clean the contact surfaces between the housing and torque plate.
2.
Align the torque plate to the gearbox ange according to the pitch of the bore belt.
3.
Fasten torque plate with screws. Observe prescribed torques!
4Preparaon ^ 21
On the housing foot
1.
Clean the contact surfaces between the housing and torque plate.
2.
Align the torque plate with the gearbox foot.
3.
Fasten torque plate with screws. Observe prescribed torques!
4Preparaon ^ 21
Mechanical installaon
Mounng
Product extensions
35